Rule 1100GPH Standard Bilge Pump – 12V

Product Overview

When servicing or upgrading bilge water management, livewell circulation and ventilation, 1100GPH Standard Bilge Pump – 12V is intended to handle removing or monitoring bilge water while matching the relevant installation or operating requirements.

Customers talk about flow, they want the water out of the bilge, and fast. Improved design and performance means that Rule's next generation 1100GPH pump will produce this flow at just 12V rather than 13.6V as previously required…more typical of on board voltage supply. Rule's next generation of Rule pumps include check valves and to do this, we've created hidden air vent to prevent airlocking.

Product Details

• Under each strainer tab there is a small hole that vents any air trapped in the pump housing preventing airlocks…and that's how we do it.
• We have true electromagnetic suppression (EMC).
• We have a built-in thermal cell that protects the pump and the vessel when things get too hot.
• We've re-engineered the inside and outside of Rule's bilge pumps, starting with a blank slate.
• And we're just getting started

Key Features

• Non-automatic – used with a panel switch or Rule float switch
• Submersible and Ignition Protected
• High efficiency, low amp motor
• Stainless-steel shaft
• Includes backflow preventer

Important Notices

WARNING: This product can expose you to chemicals including 1,3-Butadiene which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, visit P65Warnings.ca.gov.

Fit & Selection Guidance

Use manufacturer part number 27DA to verify the exact item. Confirm dimensions, voltage, capacity, material, mounting pattern, connection type and model compatibility where applicable. Replacement parts should be matched to the exact parent equipment or system whenever the manufacturer specifies one.

For installation-sensitive products, follow the manufacturer’s current instructions and the applicable marine electrical, plumbing, structural or safety requirements for your boat.