Jabsco 17820 Oil Changer System

Product Overview

For work involving marine plumbing, pumping, sanitation and fluid handling, 17820 Oil Changer System from Jabsco provides a focused option for servicing or upgrading marine plumbing, pumping, sanitation and fluid handling.

The Jabsco Oil Change System is built to be installed in a vessel's engine room with its manifold and valves permanently plumbed to the vessel's engines' oil pans or transmissions' oil sumps. The manifold is factory fitted with three ball valves to serve three different oil reservoirs and may be fitted with two additional ball valves to drain up to five oil reservoirs. The system can be used to remove old oil from an engine or transmission then reversed, with the integral reversing switch, to pump a measured amount of new oil back into the engine or transmission.

Product Details

• Each connection to an engine is controlled by a dedicated full flow ball valve.
• The system's cover offers an attractive appearance, fully shrouding the entire pump and manifold system.
• It also offers added protection against accidental draining of an engine's oil supply because the valve cover protects the factory supplied valves from being accidentally bumped open.
• Additionally, at the end of an oil change, the cover will not close unless the factory supplied valves are in the fully closed position.

Important Notices

WARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to cause cancer, and LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, visit P65Warnings.ca.gov.

Fit & Selection Guidance

Use manufacturer part number 17820-0012 to verify the exact item. Confirm dimensions, voltage, capacity, material, mounting pattern, connection type and model compatibility where applicable. Replacement parts should be matched to the exact parent equipment or system whenever the manufacturer specifies one.

For installation-sensitive products, follow the manufacturer’s current instructions and the applicable marine electrical, plumbing, structural or safety requirements for your boat.