Product Overview
When servicing or upgrading marine plumbing, pumping, sanitation and fluid handling, Impeller Kit – 12 Blade – Neoprene – 3-¾" Diameter – Brass Insert – Spline Drive is intended to handle servicing or upgrading marine plumbing, pumping, sanitation and fluid handling while matching the relevant installation or operating requirements.
Impeller Kit Material: Neoprene Drive Type: Spline Drive Number of Blades: 12 Dimensions: Diameter: 3-3/4" Shaft Width: 1" Shaft Diameter: 2-9/16" Insert Material: Brass Jabsco flexible impellers can be fitted to most makes and models of bronze flexible impeller engine cooling, bilge, transfer and general purpose pumps. Jabsco flexible impellers are subjected to rigorous quality processes to ensure dependable, efficient and long lasting performance. Replace all impellers at least once every year, or sooner, depending on the engine duty.
Product Details
- When the installation is correct an impeller may last for several years, but it is always advisable to stick to a schedule of preventative, rather than corrective, maintenance.
- Replacing impellers is easy.
- By removing the end cover screws, it is possible to remove the impeller by using either a Jabsco Impeller Removal Tool, or channel lock pliers, to grip the hub of the impeller.
- Don?t use screwdrivers as they may damage the face of the pump body, causing leaks, and they can be dangerous in confined spaces.
- Always carry spare impellers on board in case of emergency.
- The impeller is one of the most vital components of the engine cooling system and should always be treated as such.
- Always grease new impellers.
- Firstly, it makes it easier to install the impeller into the pump bore, and secondly it gives added protection to the impeller during initial prime.
- After replacing the gasket and end cover the pump is ready to use.
Important Notices
WARNING: This product can expose you to chemicals including LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, visit P65Warnings.ca.gov.
Fit & Selection Guidance
Use manufacturer part number 17935-0001-P to verify the exact item. Confirm dimensions, voltage, capacity, material, mounting pattern, connection type and model compatibility where applicable. Replacement parts should be matched to the exact parent equipment or system whenever the manufacturer specifies one.
For installation-sensitive products, follow the manufacturer’s current instructions and the applicable marine electrical, plumbing, structural or safety requirements for your boat.
Reviews
There are no reviews yet.