Sea-Dog Side Mount Rod Holder – Black

Product Overview

When servicing or upgrading marine hardware, electrical, plumbing and boat outfitting, Side Mount Rod Holder – Black is intended to handle holding or organizing fishing rods while matching the relevant installation or operating requirements.

Constructed of injection molded polypropylene. These Side Mount Rod Holders have an integral, molded-in standoff located on the back of the rod holder, allowing direct mounting to any flat surface. Accommodates rods up to 1-3/4” in diameter.

Product Details

• Installs with two #10 RH fasteners (not included).

Important Notices

WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, visit P65Warnings.ca.gov.

Fit & Selection Guidance

Use manufacturer part number 325120-1 to verify the exact item. Confirm dimensions, voltage, capacity, material, mounting pattern, connection type and model compatibility where applicable. Replacement parts should be matched to the exact parent equipment or system whenever the manufacturer specifies one.

For installation-sensitive products, follow the manufacturer’s current instructions and the applicable marine electrical, plumbing, structural or safety requirements for your boat.